from pesn.com

Rossi Cold Fusion Validated by Swedish Skeptic's Society

Yet another test of Andrea Rossi's Energy Catalyzer (E-Cat) has been performed on a 4.5 kW version near the University of Bologna. This time a new set of observers were present, one of which is the chairman of the Swedish Skeptics Society, who confirmed that Copper is being formed from Hydrogen and Nickel -- cold fusion!

Andrea Rossi grasps one of his new E-Cat units that offer a more compact size and higher power density.

by Hank Mills
Pure Energy Systems News

The evidence in support of Andrea Rossi's "cold fusion" or "LENR" (low energy nuclear reaction) based Energy Catalyzer continues to grow. For those who are not aware, his system combines nickel powder, hydrogen gas, and an input of pressure and heat to produce a large output of thermal energy. On March 29th, 2011 yet another test of the technology was performed at the University of Bologna. Like previous tests, the outcome was a complete success. However, this time a smaller version of the E-Cat was tested and two new observers were present. 

Some well known players were present during the test. These include Andrea Rossi (the inventor of the E-Cat), Professor Sergio Focardi, Dr. David Bianchini, and of course Dr. Giuseppe Levi. Two guest observers were also present. One of the guest observers was Hanno Essen, associate professor of theoretical physics at the Swedish Royal Institute of Technology. He is also the chairman of the Swedish Skeptics Society. The other guest observer was Professor Sven Kullander of Uppsala University. He is also chairman of the Royal Swedish Academy of Sciences Energy Committee.

Smaller System with Great Results

The test was performed on a much smaller version of the E-Cat. The previous version of the E-Cat had a reactor volume of about one liter. This system has a reactor volume of only one twentieth of a liter. Four E-Cat systems were present, but only one was tested. The remaining units had their shielding and insulation removed. This allowed for their construction to be seen.

This new model of E-Cat consists of a stainless steel reactor vessel which is placed inside of a copper pipe. Water flows between the copper pipe and the steel reactor vessel. There are inlets for both water and hydrogen gas. The reactor is activated by current flowing through a resistor which is wrapped around the outside of the copper pipe. When a certain temperature is reached the reaction begins. The setup is truly simple. It reminds me of old pipework from many years ago. 

Kullander and Essen were given permission to examine the setup, check for hidden power supplies, fill the reactor with hydrogen, calibrate the volume of water flow, monitor the temperature of the water flow in and out of the system, and observe the entire experiment. The reactor contained 50 grams of nickel powder and .11 grams of hydrogen. In their report (pdf) they state, "We had free access to the heater electric supply, to the inlet water hose, to the outlet steam valve and water hose, and to the hydrogen gas feed pipe. The total weight of the device was estimated to be around 4 kg."

The result of the experiment was a constant average production of 4.69 kW of power for almost six hours. Additionally, the input was on average 330 watts (30 of which was used by the electronics controlling the setup). This is fifteen times less than the energy produced by the device (15x overunity).

This output was less than the 10 to 15 kW produced by the previous version of the E-Cat, but this is very impressive for a device 1/20th the volume! 

Kullander and Essen also ruled out that the energy could be coming from a chemical source. They stated, "Any chemical process for producing 25 kWh from any fuel in a 50 cm3 container can be ruled out. The only alternative explanation is that there is some kind of a nuclear process that gives rise to the measured energy production." This statement is VERY significant coming from a report written not only by professional scientists, but also by the chairman of a skeptical society! 

Yet again, it seems the existence of cold fusion or LENR in the form of Andrea Rossi's Energy Catalyzer has been vindicated. However, there is more news to report. 

Transmutations

It is well known to those who have been following the saga of Andrea Rossi's technology that one byproduct of the system is copper. Apparently, it is the result of the fusion reaction between nickel and hydrogen. Until now, we had to take Andrea Rossi's word for that, but the results of additional testing has confirmed his claims.

A sample of fresh nickel powder and a sample of nickel powder that had been in an active E-Cat for two and a half months was given to Kullander and Essen. Elemental and isotopic analysis was performed on the samples utilizing both X-ray Fluorescence and Inductively Coupled Plasma Mass Spectrometry. The result was that the fresh nickel powder was almost totally pure nickel, but the nickel powder that had been in an E-Cat contained 10% copper and 11% iron. Two of the copper isotopes detected were Cu63 and Cu65. Kullander has stated this is proof of nuclear reactions taking place in the reactor.

Put that in your pipe and smoke it, Bob Park!

Mr. Park, are you ready to start apologizing for your many years of claiming cold fusion is simply pseudo-science, voodoo science, and snake oil? You better crawl back into the hole you came out of, because a lot of folks are going to be demanding apologies soon! 

(Go ahead and continue faking your, "cold fusion amnesia." We realize you have been avoiding talking about the topic over the past few months!)

Dumbstream Media Still Not Paying Attention

After multiple successful tests of the E-Cat by third parties, and now proof of nuclear reactions, it is frustrating (but predictable) that the mainstream media is not paying hardly any attention to this technology. The E-Cat represents a way to eliminate our need for fossil fuels and an alternative to conventional nuclear power. However, Fox News, CNN, MSNBC, and many other news networks act as if nothing is happening.

This is more proof that the mainstream media is dead, totally owned and controlled by the corrupt powers that be. If you want up to date news and information the alternative media is now the best source. At some point, awareness of this technology will reach a critical mass, and the so called mainstream media will be forced to cover it. Probably, there will be multi-hour long televised specials about the technology. The truth, of course, will be that they will not deserve the ratings they get. They ignored this technology for many months and it would serve them right if no one tuned in! I hope Andrea Rossi does not give a single major network in the United States an interview. My personal hope is that he chooses to give frequent interviews on Coast to Coast AM, and other media outlets that have frequently favorably discussed cold fusion over the years. 

Energy Revolution Coming Soon

This is further evidence that an energy revolution is coming. As the year long research program on the E-Cat technology continues at the University of Bologna, more evidence is bound to be released. Perhaps soon after the one megawatt power plant and 300,000 unit a year manufacturing plant in Xanthi, Greece opens, a factory can start up in Japan. They could sure use a source of jobs and a new source of energy to replace their destroyed conventional nuclear power industry.

The only real mystery at this point is the catalyst(s) used in the reaction. This is the key to producing practical levels of output from nickel-hydrogen fusion systems. 

# # #

This story is also published at BeforeItsNews.

Links:

• Experimental test of a mini-Rossi device at the Leonardocorp, Bologna 29 March 2011 - Participants: Giuseppe Levi, David Bianchini, Carlo Leonardi, Hanno Essén, Sven Kullander, Andrea Rossi, Sergio Focardi. Travel report by Hanno Essén and Sven Kullander, 3 April 2011.
• http://www.nyteknik.se/nyheter/energi_miljo/energi/article3144827.ece - English version of announcement
• http://nextbigfuture.com/2011/04/swedish-researchers-confirm-rossi-and.html

What You Can Do

1. Pass this on to your friends and favorite news sources.
2. Help us manage the PESWiki feature page on Rossi's technology.
3. Join the H-Ni_Fusion technical discussion group to explore the details of the technology.
4. Once available, purchase a unit and/or encourage others who are able, to do so.
5. We at PES Network are in a pinch right now.  Donations would be greatly appreciated.
6. Subscribe to our newsletter to stay abreast of the latest, greatest developments in the free energy sector.
7. Let professionals in the renewable energy sector know about the promise of this technology. 
8. Consider investing in Rossi's group.